Wiring Part 2: The Final Installation

I sort of left the wiring job hanging as far as the blog is concerned. I wrapped up the gauges and tail lights, as well as the stop switch which to my surprise and enjoyment was still operational after 63 years of service.

Here is the back of my gauge cluster. You can see the freshly rewired instrument lights as well as the 12v to 6v reducers. The empty hole un the upper left portion is for my fuel gauge I'm not runing it for the moment because it is ruined. I plan pn updateing the gauges with some Sunpro units that all but intall themselves, but for now the oldies will have to do.

---

This is the gauge cluster all wired up and ready to go in. Notice the switch I'm holding on the left. That is where I wired the gauge lights into the head/tail lights. That way everything comes on with the headlights. All new wires oh yea!

---

Here we're looking at the completed and reinstalled gauges. The chrome on the trim ring was in rough shape so stripped it and shot it with some almaond colored spray paint until I can figure out a more permanent option. I cleaned up the gauge faces and repainted the indicator needles before reassembly. I also superglued the needle of the speedometer back together.

---

My original 6v horns were cooked so I got apair of aftermarket OOogas. I figured if one was awesome 2 would be even more awesomer, and I had already wired the car for two horns. But red wouldn't do.





So....

---

After disassenbly and a little adhesion promoter.

---

They were painted black.

---

Here they are just before installation black and beautiful, ready to startle unsuspecting pedestrians.

---